Results 1 to 3 of 3

Your favorite Apple, iPhone, iPad, iOS, Jailbreak, and Cydia site.


Thread: Problems using Quickpwn.....

  1. #1
    Default Problems using Quickpwn.....
    I jailbroke and unlocked my iPhone 3G (3.0 firmware) a month or so ago using Redsn0w, but reverted back to the non-jailbroken state because it was super slow (i think it was because of Winterboard.) Now I was going to try it again, however, after I jailbreak it, the carrier doesn't come up (i am using AT&T, but it is on a non-iPhone plan. What might I be doing wrong? Usually I don't have to unlock it to use this sim card, i just did it in case I sell it on ebay to buy an iPhone 3GS

  2. #2
    Retired Moderator Poseidon79's Avatar
    Join Date
    Jan 2008
    Location
    Austin, TX
    Posts
    8,264
    Thanks
    819
    Thanked 1,681 Times in 1,159 Posts

    If you have a non-iphone plan you will have to unlock. Add repo666.ultrasn0w.com and install ultrasn0w and then reboot your phone.

  3. #3
    That's odd though since the first time i jailbroke it, i didn't have to unlock it. I can put my sim card into any iphone and it will work (even though I don't have an iphone plan.)

Posting Permissions
  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •