Results 1 to 6 of 6

Your favorite Apple, iPhone, iPad, iOS, Jailbreak, and Cydia site.


Thread: Iphone can't accept SIM card! Help plz!

  1. #1
    Default Iphone can't accept SIM card! Help plz!
    Iphone was 1.02 unlocked, when i put 1.11 everything went OK.
    I put anysim card to unlock it, it went also fine.
    When i placed my SIM card after, it says invalid SIM card, both mine and AT&T card.
    Then i returned back to 1.02 all process went fine but SIM cards are still undetected.
    Modem version is right one and imei also ok.

    My steps are:
    - unlocked 1.02
    - upgrade without virginize process to 1.11 not work any SIM card
    - back to 1.02 not work any SIM card.

    please help me! How i can repair my phone ?

    thx in advance dear friends.
    Last edited by talenat; 2008-02-01 at 02:35 PM.

  2. #2
    downgrade to 1.02 again... jailbreak and in installer add i.unlock.no to your sources, refresh... go and install the virginizer pack and baseband downgrader... then unlock using anysim 1.1... you'll be back to 1.0.2 and unlocked... i suggest you then use independence to install the pre 1.1.1 upgrade then you can upgrade to 1.1.1 and jailbreak it using indepenendence and unlock it again. If you're feeling lucking... use NateTrues ibrickr special 1.1.3 edition to upgrade and you'll be in business.

  3. The Following User Says Thank You to princemarko For This Useful Post:

    talenat (2008-02-01)

  4. #3
    hi marko

    i have this problem now, can't restore 1.02 version.
    Attached Thumbnails Attached Thumbnails -problem.jpg  

  5. #4
    baaah.... dont worry about that... Connect your iphone to itunes...hold the power button and home button until you see that itunes doesnt see it anymore...then let go ONLY the top power button and keep holding the home button until itunes recognizes your iphone in recovery mode. Then go ahead and restore to 1.0.2 and jailbreak etc etc..
    Last edited by princemarko; 2008-02-01 at 07:20 PM.

  6. The Following User Says Thank You to princemarko For This Useful Post:

    talenat (2008-02-01)

  7. #5
    @marco

    restore i start with ipbrick and baseband installed but now i have
    problem with virginizer, error > "error main script execution failed" <
    what i can try now?

  8. #6
    you dont need to use the virginizer if you didnt unlock it with anysim 1.0 after you restored, if you used anysim 1.1, you are good to go. Skip that and proceed to upgrading to 1.1.1

Posting Permissions
  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •