[JamesJMcDermott]

Okay I hope I'm not doing something dumb here

I have two iPhones:

iPhone # 1 I bought used on Craigslist, I've unlocked and jailbroke it many times and I have not problem changing (up | down) its firmware.

iPhone # 2 I recently received a new 2G from Apple as replacement for one I had whose touchscreen had gone inoperable. I've tried Unlocking it with Pwnage 2.1 and iTunes (8.0 & 7.7) and QuickPwn 1.1. I've tried it with 2.1 and 2.0 Firmware.

Each time I complete the Unlock\Jailbreak it will not accept my TMobile nor my ATT SIM. It will accept the AT&T SIM when it has Apple 2.1 Firmware. With Custom Firmware when you put in the SIM it shows ... where the signal strength should be and no carrier.

This iPhone had never been activated via iTunes\AT&T and it wouldn't unlock. So I even activated it with my AT&T SIM and it behaves the same way.

I am a software developer by trade but I am not an iPhone, Linux expert.

I've reloaded Pwnage, i've re-downloaded Apple's source ipsw(s), I've regenerated the Custom ipsw(s), I tried QuickPwn. Nothing seems to Unlock this "new" 2G Phone.

I even tried doing all of the above on a PC instead of on my MAC. I just wonder whether Apple has done something to new 2G(s) to make them more difficult to unlock.

I just took it back to Apple's 2.1 again and it works fine with the AT&T SIM.

I've run out of ideas. Everything I've tried has left me with a Jailbroken but not Unlocked iPhone.

[badbeat4eva]

go to I dev team page quickpwn GUI it will fix all your problems use pc version I did it works do the bit torrent version have fun