Thread: Iphone 3Gs stuck on blackscreen
-
08-18-2011, 11:23 AM #1
Iphone 3Gs stuck on blackscreen
Hello guys.. I've got my friends ip3gs to restore it to 4.3.3 but I forgot to save SHSH now my iphone doesnt boot.. it stays on blackscreen when itry to restore with snowbreeze it gives me error 3194.. what can I do please help me..
-
08-18-2011, 11:45 AM #2
Was it jailbroken before? Did you notice any green numbers at the top of Cydia's home screen?
Error 3194 occurs because the iOS is not authorized to restore.
Download and run Tiny Umbrella and Save SHSH. Do this with 'get from Cydia' both checked and unchecked.
What SHSH blobs do you have?
Note: Apple is authoriziing 4.1 at the moment. That may be your only option.
-
The Following User Says Thank You to Mes For This Useful Post:
Petrit H (08-18-2011)
-
08-18-2011, 11:57 AM #3
no it was clean with at&t card.. but I cant save SHSH because tiny umbrella doesnt recognize the iphone... any other solutions?
-
08-18-2011, 12:04 PM #4
If you know the ECID, it can be manually entered in Tiny Umbrella.
Oh yea, USBDeview can extract the ECID while in DFU mode too
If that doesn't work, you could restore to a stock 4.1 since Apple is authorizing it at the moment.
You'll likely receive a iTunes 1014/5 error. TU's 'exit recovery' should bypass that error.
-
The Following User Says Thank You to Mes For This Useful Post:
Petrit H (08-18-2011)
-
08-18-2011, 12:05 PM #5
I used redsnow and just boot tethered.. now im on 4.3.3 but cant save SHSH... what can i do?
-
08-18-2011, 12:08 PM #6
What do you mean 'can't save SHSH'? Does Tiny Umbrella report an error? Or no SHSH blobs are available?
-
The Following User Says Thank You to Mes For This Useful Post:
Petrit H (08-18-2011)
-
08-18-2011, 12:09 PM #7
-
08-18-2011, 12:10 PM #8
OK. No errors. That's good
Don't need the ECID info now because you have the info already.
As expected, the only option is loading 4.1 using my prior instructions.
-
The Following User Says Thank You to Mes For This Useful Post:
Petrit H (08-18-2011)
-
08-18-2011, 12:13 PM #9
even that im on ipad basband should I use the stock ipsw or I have to make one with snowbreeze? for 4.1? and after I go 4.1 can I install 4.3.3 then?
-
08-18-2011, 12:16 PM #10
With the iPad BB installed, you need a custom firmware + activate option (if no authorized SIM).
Enter pwnd-DFU mode w/Sn0wbreeze, and load cfw w/iTunes.
If iTunes reports and error, use TU's 'exit recovery'
Note: TU is not needed for the restore. Apple is authorizing 4.1
Note: 4.3.3 is not an option because no SHSH blobs are available
-
The Following User Says Thank You to Mes For This Useful Post:
Petrit H (08-18-2011)
-
08-18-2011, 12:17 PM #11
Can I then upgrade to 4.3.3 or will still fail?
-
08-18-2011, 12:18 PM #12
4.3.3 is not an option because no SHSH blobs are available
-
08-18-2011, 12:20 PM #13
oh well, now I have to wait for 4.3.5 untethered jailbreak then

thanks a lot mate.
-
08-18-2011, 12:23 PM #14
Note: Use the Sn0wbreeze version for iOS 4.1 from ih8sn0w.com web site.
-
08-18-2011, 12:24 PM #15
thanks mate.. thanks again... damn i wanted that 4.3.3 so much.. :S
-
08-18-2011, 12:29 PM #16
You're welcome.



LinkBack URL
About LinkBacks
Reply With Quote
